Sparkfun BusPirate case

Hi everyone,

As you might have guessed from my last post, I'm into 3D printing theses days. And I didn't know what to print today, so I thought about my old friend, my BusPirate. I have the Sparkfun flavour of the BusPirate (which is v3.5 if I remember well). It is a little bit trimmed on the edges since I had a previous attempt with a case from Thingiverse (but which wasn't for SF Buspirate so it didn't fit in the end :/), but works well.

And I decided I'd make it a nice case, just to protect it when I carry it around. Dimensions are half measured / half guessed since I don't have any calipers on hand, just a regular ruler. The case doesn't need any glue or screw, just press the two parts and it'll stay closed. I did'nt need any fancy stuff like mounting holes so there aren't any. it is also quite smaller than the case you could find on thingiverse (for the Sparkfun BP).

I designed it with Catia V5 (that I have access to from school), so I just upload the STL files. If anyone want the CATParts, just ask, I'll send them to you.

Download Here

The picture is not really good and the surface isn't either (I know I need to reapply kapton tape on the heatbed but tonight I was a bit lazy so it's as it is.)

 

Bye

RedoX++;

Majeur maint'nant, bientôt l'permis et j'espère au final une bonne moto.
A c'propos je vends la mienne (Daelim Roadwin 125) et cherche un gros cube de 34ch, si vous avez des infos, êtes intéressés, n'hésitez pas (j'ai peu d'espoir mais sait-on jamais)

Cheers ;)